Part III. Matters of anchoring

↑

⇐ ПредыдущаяСтр 2 из 10Следующая ⇒

PART III. MATTERS OF ANCHORING

A. Sailors work

1. Hans turned to washed deck down as usual

2. Hands turned out to watch decks down

3. Hands employed in washing fore and aft decks

4. Crew washed ships outside

5. Hands turned to broomed decks down

6. Hands holystoned decks

7. Hands varnishing hand rails

8. Hands employed in chipping fore deck

9. Hands chipping foredeck

10. Turned to work scrubbing weather deck

11. Resumed work engaged in the same work as forenoon

12. Crew engaged in general cleaning

13. Hands stopped work

14. Hands resumed work

15. Hands knocked off

16. Hands knocked off for the day

B. Chipping and Scraping

1. Hands chipped foredeck

2. Hands, employed in chipping and scaling

3. Deck hands employed in scaling in #1 Hold

4. Crew chipping and scraping rusty parts of funnel, ventilators and engine room casing

5. Engaged in chipping and scaling the top plates of #1 Ballast tank with pneumatic tools

6. Engaging in chipping rusty parts on mast table

7. Employed in chipping all over the weather decks with scaling machine

8. Hands employed chipping the top plates of #3 Oil tank after ensuring gas free

C. Painting, Varnishing, Tarring and Cementing

1. Hands employed in painting masts and derricks

2. Painting hatch coaming and touching up ships outside

3. Painted bridge front bulkhead after soaping

4. Started first coating of #1 Composition

5. Finished second coating of #2 Composition

6. Hands blacking down riggings stays of the fore mast

7. Crew tarred on bunker deck

8. Quartermasters employed in varnishing wheel–house

9. Hands varnished skylights, cabin doors and hand rails

10. Cementing inside of #1 Ballast tank and forepeak tank

11. Tar–cemented on #1 Ballast tank top

12. Stopped painting owing to passing shower

13. Scraped splashed paint on deck

D. Cleaning

square up – приводить в порядок

1. Hands (employed in) cleaning crew’s quarter

2. Soaped down bridge front

3. Cleaning up boat and gears

4. Wiping paint work on poop deck

5. Scoured bright work in saloon entrance

6. Cleaning all stores belonging to the deck department

7. Cleaned cargo hold after discharging coal, using saw dust

8. Cleaned under bridge, using acetic acid to remove the smell of salted hides

9. Hands cleaning up limbers in ## 1,2 and 3 Cargo Holds

10. Polished brass work on bridge

11. Soda washing bright work of chart room and soap washing officer’s quarter

12. Removed paint splashes on hatch

E. Repairing

1. Repaired signal flag

2. Caulking bridge deck

3. Overhauling sounding machine and greasing sounding wire

4. Straightening stanchions and repairing variously

5. Faired bent rail stanchions in place

6. Renewed port main rail on poop deck

7. Partly renewing bottom ceiling in #2 Hold

8. Refitted broken port glass in wireless room

9. Hands employed in oiling all fair–leaders on board

10. Engaged in overhauling and oiling all cargo gears

11. Employed repairing boat covers

F. Making and fitting

1. Hands employed in making fenders for life boats

2. Make #2 Hatch tarpaulins

3. Fitted up hawse plugs and vegetable locker

4. Carpenter fitted molding underneath upper bridge with assistance of two sailors

5. Quartermasters fitting relieving tackle

6. Fitting cargo batten in #1 Hold

7. Setting up rigging ratlines of foremast

8. Eased pipe at #2 Hold

9. Engaged in pointing the rope’s ends

G. Preparation for Cargo work

Познавательные статьи:



Техника прыжка в длину с разбега

Организация работы процедурного кабинета

Области применения синхронных машин

Оптимизация по Винеру и Калману